Fiber
optic cable manufacturing machine can blow OFC
of size 9 mm to 16 mm dia of any configuration whether armored or unarmored
cable into the ducts of size 25 to 63 mm. The machine is powered by 835 RPM
High power ModecMT20 air motor. Anodized Aluminium air chamber unit to prevent
from fungus and corrosion.
The blowing machine requires no dedicated
operator to run the machine because its very simple to operate with semi
skilled operator and very easy to shift from one work site to other since
machine weighs only less than 38 kg. Also assembling at work site takes few
minutes, saves lot of time and fuel, with low maintenance.
The machine
is provided with all accessories required for cable blowing
like Rubber ‘U’ seals , split couplers , Filter lubrication system, Duct
cutter, Allen Key set, Fiber Hammer, Spare bolts and nuts.
KEY FEATURES
The machine
is provided with all accessories required for cable blowing like Rubber ‘U’
seals , split couplers , Filter lubrication system, Duct cutter, Allen Key set,
Fiber Hammer, Spare bolts and nuts.
Over view
Fabrication:
Aluminum Casting
§ Body Finish: Powder Coating
§ Cable Dia(mm) : 09 to 16
§ Duct OD(mm) : 25 to 63
§ Drive Unit : Pneumatic motor
§ Speed at Max power (RPM) : 835
§ Free Speed (RPM) : 1946
§ PushingForce(N) : 0 - 260
§ Linear Pressure on
Cable(N/cm) : 94
§ Max.Speed (m/min) : 75
§ Air Consumption : 1800 l/min
§ Pressure of Use : 6 bar
§ Air inlet for Duct pressure :
11 Kg/cm2
